Premier's Cut out Tester is used to measure the ON time of the appliance. This instrument is used to measure the time required by the heater or heater based appliance like geyser, iron, hair dryer, etc. to reach the cut out temperature.
MODEL : PE 920
* Designed with relevant ISI drafted specification to measure ON time of a thermostat based appliance.
* Direct display of ON time and test voltage.
* Easy to use.
Power : 230 V AC ± 10% 50Hz
DIGITAL TIMER SECTION
Display : 3 digit, 0.5" Ht, red LED
Range : 0-99.9 sec Resolution : 0.1 sec
Time base : Quartz Crystal based Oscillator.
Accuracy : 0.05% ± 1 count
Count mode : Up-The timer starts counting up and stops and latches to the last reading when Thermal cut out trips off.
Reset : Manual
DIGITAL AC VOLTMETER SECTION
Display : 3 digit, 0.5" ht red LED.
Range : 0-300 V AC
Resolution : 1 V AC
Accuracy : 0.5% ± 1 count
Dimensions : 220(W) X 70(H) X 180(D) mm3
Other Relevant Products:
Insulation Tester- Click here
HV Breakdown Tester- Click here
Temperature Controller-Click here